| Wiki Markup |
|---|
h2. Cylinder Head and Valvetrain
!b305-116-8.img01.gif!
Pinch clips (*arrows*) to disconnect vent line from cylinder head cover.
!b305-116-8.0021795a.gif!
Remove ignition coils:
* Disconnect ignition coil harness connectors.
* Remove coil mounting fasteners.
* Remove coils.
* Remove ground straps.
* Set coil harness to side of engine compartment.
{note:title=CAUTION}Note location of all ground wires. Failure to reinstall grounds can result in permanent damage to engine control module or ignition system components.
{note}Remove cylinder head cover mounting fasteners and remove cylinder head cover.
{info:title=NOTE}In order to reinstall cylinder head cover mounting bolt insulator and gaskets in their original locations, make note of their arrangement during removal.
{info}
!b305-116-8.502113886.gif!
Installation is reverse of removal. Keep in mind the following:
* Make sure sealing surfaces are clean and free of old gasket material.
* Replace cylinder head cover gasket, as well as rubber insulators and seals as necessary.
* Use a small amount of 3-Bond®1209 adhesive or equivalent at corners (*arrows*) of half-moon cut-outs at back of cylinder head.
* Seat gasket and seal corners in front of cylinder head at VANOS unit.
* Inspect cylinder head cover mounting screw assembly rubber seals. Replace if rubber is cracked or brittle.
{panel:title=Tightening torque|borderColor=#999|titleBGColor=#eee|bgColor=#fff}
Cylinder head cover to cylinder head . . . {color:red}10 NM (89 in-lb){color}
{panel}
_Cylinder Head_
----
h6. _[Click here to view/download PDF|PDF^rbi-errata-b305-116-8.2006-05-26.pdf|Document appears as images on this page and pdf source can be saved by clicking on this link.]_
!Included Images^rbi-errata-b305-116-8.2006-05-26.jpg|border=1!
{bpyoutube}
Valvetrain  Image Added Pinch clips (arrows) to disconnect vent line from cylinder head cover.  Image Added
Remove ignition coils: - Disconnect ignition coil harness connectors.
- Remove coil mounting fasteners.
- Remove coils.
- Remove ground straps.
- Set coil harness to side of engine compartment.
| Note |
|---|
| Note location of all ground wires. Failure to reinstall grounds can result in permanent damage to engine control module or ignition system components. |
Remove cylinder head cover mounting fasteners and remove cylinder head cover. | Info |
|---|
| In order to reinstall cylinder head cover mounting bolt insulator and gaskets in their original locations, make note of their arrangement during removal. |
 Image Added
Installation is reverse of removal. Keep in mind the following: - Make sure sealing surfaces are clean and free of old gasket material.
- Replace cylinder head cover gasket, as well as rubber insulators and seals as necessary.
- Use a small amount of 3-Bond®1209 adhesive or equivalent at corners (arrows) of half-moon cut-outs at back of cylinder head.
- Seat gasket and seal corners in front of cylinder head at VANOS unit.
- Inspect cylinder head cover mounting screw assembly rubber seals. Replace if rubber is cracked or brittle.
| Panel |
|---|
| borderColor | #999 |
|---|
| bgColor | #fff |
|---|
| titleBGColor | #eee |
|---|
| title | Tightening torque |
|---|
| Cylinder head cover to cylinder head . . . 10 NM (89 in-lb) |
Cylinder Head
 Image Added
| 
