Abstract: This page outlines crankshaft sealing flange replacement procedure. Flange installation requires a special Volkswagen tool tool (press tool no. T10134 tool) to properly index press on the rear main seal as well as indexing the crankshaft sensor wheel to the TDC position of the crankshaftcrankshaft TDC (Top Dead Center).
The crankshaft sealing flange includes the crankshaft rear main PTFE-seal and the crankshaft position sensor wheel as an assembly. Incorrect installation of the flange (with seal and sensor wheel) will resulted asssembly will result in a no-start condition, and an ECM error code(s) (improbable engine speed sensor signal). Oil pan removal is also required as part of this repair procedure.
Read the procedure through to determine what parts and supplies are required before beginning the repair.
Video courtesy of Elring GmbH:
| Widget Connector | ||
|---|---|---|
|
...
Applies to:
2009 2005 - 2011 Volkswagen Jetta - engine codes BRM, CBEA, CJAA (TDI)
...
| Section | |||||||||||||||||||||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
