ELECTRICAL SYSTEM6.2 Removing and Installing Starter| Warning |
|---|
| Before removing starter mounting bolts install an engine lifting device to support the weight of the engine. See 3. Engine |
To remove the starter, first disconnect the ground strap from the negative  battery terminal. On cars with automatic transmission, work beneath the car to remove the two bolts that hold the cover plate to the starter, and remove the plate. Disconnect the wire to terminal 50 and the positive  battery cable from the starter solenoid. Note the location of any other wires attached to the starter and then disconnect them. Remove the bolts that hold the starter to the transaxle bellhousing and remove the starter. On cars with automatic transmission, it is also necessary to remove the bolt holding the starter mounting bracket to the engine. Inspect the starter. Replace or repair the starter if the drive pinion teeth are worn or broken. On cars with manual transmission, inspect the starter bushing that is pressed into the transaxle's bellhousing. If the bushing is worn or damaged, it should be replaced as described below. | 
