Abstract: General information for replacing a motor mount
Applies to: BMW X3 (E83) 2004- 2010
General information for replacing a motor mount
- Disconnect battery negative cable and cover cable end with insulating material.
- Support engine from above using appropriate lifting equipment. Raise engine about 10mm, or just until weight of engine is supported.
- Remove nut from lower and upper nut from mount and remove. If necessary raise engine slowly just enough to gain clearance. Check carefully for obstructions if raising engine.
- Replace self locking nuts. Tighten to specification:
Tightening torque
Mount to mount bracket M10 Nut (10.9 grade). . . 56 NM (41 ft-lb)
Mount to body or suspension crossmember M10 bolt 38 Nm (28 ft-lb)
- Reconnect battery negative cable.
Before Performing Any Work
Please read all Warnings & Cautions before proceeding with any work on your vehicle.
Related Technical Manuals
Technical Discussion Forums