Abstract: This page outlines crankshaft sealing flange replacement. Flange installation requires a special Volkswagen tool (press tool no. T10134 tool) to properly press on the rear main seal as well as indexing the crankshaft sensor wheel to crankshaft TDC (Top Dead Center). 

The crankshaft sealing flange includes the crankshaft rear main PTFE-seal and the crankshaft position sensor wheel as an assembly. Incorrect installation of the flange asssembly will result in a no-start condition, and an ECM error code(s) (improbable engine speed sensor signal). Oil pan removal is also required as part of this repair procedure.

Read the procedure through to determine what parts and supplies are required before beginning the repair.

Video courtesy of Elring GmbH:

Applies to:
2005 - 2011 Volkswagen Jetta - engine codes BRM, CBEA, CJAA (TDI)

13 - Crankshaft rear sealing flange,removing and installing

Crankshaft sealing flange, flywheel side

Click here to view/download PDF

Before Performing any Work

Please read Cautions and Warnings before proceeding with any work on your vehicle

Related Technical Manuals

	Volkswagen Jetta (A5) Service Manual: 2005-2010
	Volkswagen Rabbit, GTI (A5) Service Manual: 2006-2009 2.0L FSI, 2.5L

More Volkswagen products...

Technical Discussion Forums

more...

Subscribe to RSS feed