Disconnect battery negative cable and cover cable end with insulating material.
Support engine from above using appropriate lifting equipment. Raise engine about 10mm, or just until weight of engine is supported.
Remove nut from lower and upper nut from mount and remove. If necessary raise engine slowly just enough to gain clearance. Check carefully for obstructions if raising engine.
Replace self locking nuts. Tighten to specification:
Panel
borderColor
#999
bgColor
#fff
titleBGColor
#eee
title
Tightening torque
M8 (8.8 Mount to mount bracket M10 Nut (10.9 grade). . . 24 56 NM (18 41 ft-lb)
M8 (10.9 grade). . . 34 NM (25 Mount to body or suspension crossmember M10 bolt 38 Nm (28 ft-lb)
Reconnect battery negative cable.
Column
width
35%
Warning
title
Before Performing Any Work
Please read all Warnings & Cautions before proceeding with any work on your vehicle.