Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 4 Next »

Abstract: General information for replacing a motor mount


Applies to: BMW X3 (E83) 2004- 2010


General information for replacing a motor mount

  • Disconnect battery negative (minus) cable and cover cable end with insulating material.
  • Support engine from above using appropriate lifting equipment. Raise engine about 10mm, or just until weight of engine is supported.

 

  • Remove nut from lower and upper nut from mount and remove. If necessary raise engine slowly just enough to gain clearance. Check carefully for obstructions if raising engine.

 

  • Replace self locking nuts. Tighten to specification:

 

Tightening torque

M8 (8.8 grade). . . 24  NM (18 ft-lb)
M8 (10.9 grade). . . 34 NM (25 ft-lb)

  • Reconnect battery negative (minus) cable.

 

 

Before Performing Any Work

 Please read all Warnings & Cautions before proceeding with any work on your vehicle.

Technical Discussion Forums

 


 


 

  • No labels