Abstract: General information for replacing a motor mount
...
Applies to: BMW X3 (E83) 2004- 2010
...
Section |
---|
Column |
---|
| <article content> | - Disconnect battery negative cable and cover cable end with insulating material.
- Support engine from above using appropriate lifting equipment. Raise engine about 10mm, or just until weight of engine is supported.
Image Added - Remove nut from lower and upper nut from mount and remove. If necessary raise engine slowly just enough to gain clearance. Check carefully for obstructions if raising engine.
Image Added- Replace self locking nuts. Tighten to specification:
Panel |
---|
borderColor | #999 |
---|
bgColor | #fff |
---|
titleBGColor | #eee |
---|
title | Tightening torque |
---|
| M8 (8.8 grade). . . 24 NM (18 ft-lb) M8 (10.9 grade). . . 34 NM (25 ft-lb) |
- Reconnect battery negative cable.
|
Column |
---|
| Warning |
---|
title | Before Performing Any Work |
---|
| Please read all Warnings & Cautions before proceeding with any work on your vehicle. |
|
|