Abstract: Article updating repair information found in Bentley's BMW 3 Series: > 1998 Repair Manual, regarding VANOS control unit, installing - page 117-17 (B398)
Applies to: BMW 3 Series (E36) Service Manual: 1992-1998 - BSIN B398
VANOS control unit, installing
CAUTION
Incorrect installation of the VANOS control may result in damage to the engine valvetrain.
1. Lock camshafts and crankshaft in TDC position with BMW special tools as described above in removal procedure.
CAUTION
The camshafts and crankshaft must be locked in the TDC position using BMW special tools no. 11 2 300 and 11 3 240. If the camshafts and crankshaft are not at TDC, the valves can contact the pistons when the engine is turned over.
NOTE
Be sure the secondary timing chain tensioner is locked down and the exhaust camshaft mounting bolts are loose before proceeding.
2. Remove primary timing chain tensioner from side of cylinder head. See Fig. 40.
Fig. 40. Primary timing chain tensioner (arrow). Remove tensioner slowly to relieve spring tension beneath end plug.
3. Install BMW special tool no. 11 3 390 into primary timing chain tensioner sleeve. Thread tool in finger tight to remove chain slack.
NOTE
BMW special tool no. 11 3 390 is a dummy chain tensioner and simulates the function of the tensioner.
4. Hand turn secondary sprockets clockwise (as viewed from front of engine) until sprockets contact stops.
5. Apply a small amount of liquid gasket sealer (3-Bond 1209® or equivalent) to VANOS housing alignment dowels on front of cylinder head. Install a new gasket.
6. Push VANOS piston gear cup into VANOS housing until it bottoms out in housing. Position VANOS control unit into place, but do not engage splines on gear cup.
7. On cars built up to 3/95:
- hand turn exhaust sprocket counterclockwise (as viewed from front of engine) only enough to mesh
VANOS (VARIABLE VALVE TIMING)
Click here to view/download PDF
null
Before Performing any Work
Please read Cautions and Warnings before proceeding with any work on your vehicle
