Adjusting Front Wheel Bearing Mercedes-Benz C-Class 1994-2000 (W202)
Abstract: This article describes Adjusting Front Wheel Bearing Mercedes-Benz C-Class 1994-2000 (W202) C280
Applies to: Mercedes-Benz C-Class 1994-2000
- Raise car and support safely.
- Remove wheels.
Warning
Make sure the car is stable and well supported at all times. Use a professional automotive lift or jack stands designed for the purpose. A floor jack is not adequate support.
* Screw in lug bolt (48a) across from the brake rotor attachment bolt to secure brake rotor.
- Press brake pads back into brake caliper.
- Pull off hub cap (9e).
- Slacken hexagon socket head screw (9i) and lightly tighten clamping nut (9d) whilst rotating the wheel hub. Then turn clamping nut (9d) back until play is noticeable.
- Attach dial gauge (022) to dial gauge holder (015).
- Adjust wheel bearing play by turning the clamping nut (arrow) in stages while pushing and pulling the brake disk firmly back and forth.
- Tighten Allen bolt (9i), check the wheel bearing end float again.
- Remove dial gauge (022) with the dial gauge holder (015.
- Reassemble front wheel. Depress brake pedal several times to seat barke pads.
Model 202 |
||
|---|---|---|
|
Wheel bearing play at front axle |
mm 0,01-0,02 |
Torque |
Bolt for clamping nut to adjust front axle wheel bearing play |
NM 11 |
Before Performing any Work
Please read Cautions and Warnings before proceeding with any work on your vehicle
Related Technical Manuals
Technical Discussion Forums
