Abstract: General information for replacing a motor mount
Applies to: BMW X3 (E83) 2004- 2010
General information for replacing a motor mount
- Disconnect battery negative
cable and cover cable end with insulating material. - Support engine from above using appropriate lifting equipment. Raise engine about 10mm, or just until weight of engine is supported.
- Remove nut from lower and upper nut from mount and remove. If necessary raise engine slowly just enough to gain clearance. Check carefully for obstructions if raising engine.
- Replace self locking nuts. Tighten to specification:
Tightening torque
M8 (8.8 grade). . . 24 NM (18 ft-lb)
M8 (10.9 grade). . . 34 NM (25 ft-lb)
- Reconnect battery negative cable.
Before Performing Any Work
Please read all Warnings & Cautions before proceeding with any work on your vehicle.
Related Technical Manuals
Technical Discussion Forums
