BMW ATF Service for A5S 440Z automatic transmissions
Abstract
Revised ATF service (drain and fill capacity)Â for the A5S 440Z automatic transmisisons, reference page 240-7 See Document 3 at bottom of page.
Specifications for automatic transmission fluid capacities disagree within factory service information website (www.bmwtechinfo.com), as documented below.
Applies to: BMW 7 Series 1995 - 2001 - 8 cylinder models (platform: E38)
A5S 440Z (5 speed) used on 01/1997 -Â 2001 740i
Recommended service procedure
A good way to be sure the correct amount of fluid is refilled is to measure the amount of fluid that was initially drained out. Of course this assumes the correct amount of fluid was in the transmission prior to draining.
When refilling, pump in the same amount of fluid that was initially drained out (or as much as it will take with the engine off). Then follow the procedure in the manual for checking the ATF level (run engine until ATF temp reaches 30- 50 degress C, add fluid until is spills from fill hole). Recheck fluid level after driving car and shifting through all gears.
Note
Use only transmission fluid approved for use by BMW. All other fluids will cause non-warrantable transmission damage.
Mixing different types of transmission fluids will lead to transmission failure.
Below is the factory technical data sheet for the A5S 440Z (Document 1). Directly following this sheet is the revised capacity as found in an attachment to BMW service bulletin published in September 2001 (SI B 24 01 98) (Document 2). Note the discrepency in Oil change volume.
Note
 Compare oil change volume in each factory document.
Document 1
Click here to view/download PDF
Document 2
Click here to view/download PDF
Document 3
Corrected page:
Note
Changes are shown in Red
Click here to view/download the corrected page - PDF
Before Performing any Work
Please read Cautions and Warnings before proceeding with any work on your vehicle